If none of these work, you can try cleaning it with the steps in the step-by-step guide 2 sections below. You can also unplug / plug the wiring harness from the bottom sockets may work. The contact pads inside can get dirty so sometimes simply wiggling them around works. So if you purchase a non-OEM rocker switch with the PACKARD connector, you will have to rig up your own wiring adapter harness, which will probably involving cutting off the female adapter from the snow blower. I spoke to Carling Technologies that this harness is ONLY AVAILABLE as part of the B&S kit and that it cannot be purchased separately anywhere else. The problem is that the receiving connector on your snowblower is the original Euro-Look 6 pronged female connector.īriggs OEM kit comes with a proprietary adapter harness so that you can simply install your new rocker switch, plug in the harness in between the new rocker switch and the Euro-Look female connector. If you want the simplest solution, click here to just buy the genuine Briggs & Stratton Wire Harness Adapter kit # 11687904.Īll current rocker switches, including non-OEM parts, come in a PACKARD / AMP style connector. However, if you still cannot turn to the left after flipping over the switch, you most likely have a bad motor (check my John Deere 1330se Resource page to look for a solution).This indicates that you have a faulty rocker For example, let’s say that you are able to turn the chute to the left only but you can when the switch is flipped.If your chute is rotating to one side but not the other, you can simply unplug and flip the bottom of the switch upside down to see if the problem gets reversed.The rocker used in JD 1330se consists of 6 wires in a floating ground where the middle 2 contact pads provide ground and power. The name “rocker switch” comes from the rocking motion that the switch makes when the button is pressed and it is also sometimes called a seesaw switch. They are often used as ON/OFF switches on the main power supplies for electronic devices. Rocker Switches house a button for operation that can be pressed on either end like a seesaw to connect or disconnect an electrical circuit. Replacement parts mentioned in this article should be applicable to these snowblower brands/models: Electric chute rotator switch fails to rotate to the left and/or to the right side.If you arrived on this via search engine, click here to visit my John Deere 1330se Snowthrower Resource pageĬoupled with John Deere 1330se electrical system not having any fuses, other electrical problems, such as dim or non-lit headlights can mask the root cause of a problem.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |